Day 6, 25th May 2006 - The engine & the gearbox

There is always something to do on the side (most likely it is Andy's C-Kadett)..



Devorced....

Day 5, 22th May 2006 - Cables, Cables & again, Cables...

Vacum valve, ledt side












Hakan, watching all over...

Spare cables
Grounding cable & ignition spool plug
Front cable too long, so better loop it
Grounding, left, inside
Gas pump cable
whiper engine and connector
Front light (left) cable & grounding point
Cable for rear whiper

In the back, some connector on the right side

Day 4, 12th May 2006 Rust, rust, rust....

No comments.....

Day3, 11th May 2006 The dashboard & the cable loom

Alright, here goes the dashboard! Serious stuff that requires some concentration (and actually took some time as well).

I better remember how that one is supposed to be placed!
The first look at the main part of the cable loom, isn't it nice and confusion at the same time? You better flag each plug for later!

Day2, 6th May 2006 - The rollbar..

Unfortunately, I had to pay tribute to the transportation and cut the rollbar but a good weldering solved the problem. Next came the adaptation of the rollbar which tooke a whole day to get it fitting inside the car body. Finally after a lot of pressure and tension it was done: back out again and looking forward to the next steps.....

Well, even child-care is possible at a workshop, ya just oughta have the right ideas!

Day1, 29th April 2006, Stripping down the interior

The show has started and the long awaited project has finally come to the point of no return!

Day1, 29th April 2006: Stripping down the interior

Looks good without backseats and was done quicker then expected.